The Agilent E4416/17A EPM-P Series power meters provide peak, average, peak-to-average ratio and time-gated measurements, using the E9320 peak and average power sensors. The E4416/17A are compatible with all 8480 and E-series power sensors.

The E4416A is a single-channel power meter.

The E4417A is a true dual-channel power meter, which means that you get two simultaneous power readings on the display.

The E4416/17A do not have legacy power meter code compatibility because they are targeted at new applications such as time-gated power measurements. Code compatibility is however provided by the EPM Series power meters (E4418B and E4419B) as they are a direct replacement for the 436A, 437B and 438A.

• Simultaneous peak, average and peak-to-average ratio power measurements
• Time-gated power measurements
• Up to 1,000 corrected readings per second over the GPIB
• 20 Msamples per second sampling rate for reliable continuous and single shot measurements on wide bandwidth signals
• Compatible with all 8480 and E-Series power sensors
• Easy-to-read display - large 1-line or 4-line numeric display, or trace display, or an analog display
• 8 pre-defined wireless configurations (GSM, EDGE, NADC, iDEN, Bluetooth, IS-95 CDMA, W-CDMA and cdma2000)

The Agilent E4418/19B are low-cost, high-performance, programmable RF power meters. They are fully compatible with the 8480 series and the E-Series power sensors (except the E9320A family). Depending upon which sensor is used, the E4418/19B can measure from -70 dBm to +44 dBm at frequencies from 9 kHz to 110 GHz.

Designed for bench and ATE use, the E4418/19B makes fast (up to 100 readings per second with E-series sensors), accurate and repeatable power measurements.

The E4418B is a single-channel power meter.

The E4419B is a true dual-channel power meter, which means that you get two simultaneous power readings on the display.

• Fast measurement speed (up to 100 readings per second, over the GPIB, with E-Series sensors)
• Speed improvement of x2 using the 8480-Series power sensor (compared to the 437B)
• No range-switching delays with 8480 series sensors, and only one fast-range switching point with E-Series sensors
• RS-232/422 Interfaces as standard
• GPIB Interface for remote control of all functions
• Code compatibility with HP 436A/437B (E4418B) and 438A (E4419B)